71
Detail program description - Copy / Erase
03
04
01
01:23hR16
Ultimate
02
Graubele
1234g/080811
00:44hR12
Starlet
BELL47G
00:33hR08
00:22hR08
Test
trim needed
Copy to model:
¿¿¿
free
¿¿¿
05
After confi rming the selected model memory with
a tap on the
SET key, a confi rmation request will
appear:
Model really
Ultimate
to be copied?
NO
YES
02
05
¿¿¿
free
¿¿¿
A NO response will cancel the process and return
the screen to the originating screen. If the f YES
response is selected and confi rmed with a tap on
the
SET key then the selected source model will be
copied into the selected model memory destination.
Note:
In addition to model data, binding data is also copied
by this process. This means that a receiver system
which was/is bound to the original model memory can
also be operated by its copy without establishing the
bond again.
Exporting to SD card
Use the cd selection keys of the left or right touch
pad to select the »Export to SD« sub-menu then tap
on the
SET key.
Copy flight sen kopieren
Erase model
Copy modeModell –> Modell
Export to SDach SD-Karte
Import from von SD-Karte
=>
OFFON
Please select
RF on/off?
If the message shown above should appear, the
transmitter's RF module is still active. Switch the
RF module off as described on page 80 then also, if a
receiver system is currently switched on, switch off that
receiver too. This is to be done for reasons of safety.
Choose the model to be exported with the cd
selection keys of the left or right touch pad …
03
04
05
01
¿¿¿
free
¿¿¿
01:23hR16
Ultimate
02
Graubele
1234g/080811
00:44hR12
Starlet
BELL47G
00:33hR08
00:22hR08
Test
trim needed
export to SD-Card:
After confi rming the selected model memory with a tap
on the
SET key, a confi rmation request will appear:
Model really
Ultimate
export?
NO
YES
02
A NO response will cancel the process and return
the screen to the originating screen. If the f YES
response is selected then confi rmed with a tap on the
SET key, the selected model will be copied to the SD
card.
Notes:
Should the notice …•
SD-CARD
INSERT
OK
… appears instead of a screen for model
selection, there is no SD card in the transmitter's
card slot, see page 23.
In addition to model data, binding data is also •
copied by this process. This means that a receiver
system which was/is bound to the original model
memory can also be operated in the SAME
transmitter by its copy without establishing the
bond again.
An exported fi xed-wing model will be stored on •
the memory card in the \\Models\mc-20 folder
with a fi lename format of "aModelname.mdl"
and a helicopter model with a fi lename format
of "hModelname.mdl". On the other hand, if a
"nameless" model is exported, its data will be
stored on the memory card under "ahNoName.
mdl" or "hNoName.mdl", as appropriate.
Some special characters that can be used in •
model names are subject to specifi c restrictions
associated with the FAT or FAT32 fi le system used
by the memory cards and these special characters
will be replaced during the copy process with a
tilde (~).
A model fi le already on the memory having •
the same name as the fi le to be copied will be
overwritten without warning.
To Next Page
Loading...
Need help?
General
