34 Transmitter description - Secret mode
¾
¾
¾
¾
¾
¾
Firmware Download
Prozess Start
Please Wait....
¾
¾
¾
¾
¾
¾
Boot Download
Success!!!
Please Wait....
…, the message:
¾
¾
¾
¾
¾
¾
Firmware
Downloading...
Progress 023/275
… will appear in the display. As soon as the counter
to the left of the "/" character reaches the value
shown on the right as the volume to be loaded, the
message …
¾
¾
¾
¾
Firmware Upgrade
Success!!!
… will appear. After a few seconds this message
will be erased and the transmitter will automatically
restart. The transmitter is now again operational.
Notes:
If the warning …•
SD-CARD
INSERT
OK
… appears then the transmitter does not detect
a memory card in its card slot or the card found
cannot be read.
If the selection window is empty …•
FILE LIST
… then the transmitter could not fi nd a suitable
fi rmware fi le on the inserted memory card. Check
the contents of the SD card's "Firmware" directory
on a PC or laptop.
JOYSTICK CALIBRATION
If you feel the neutral position of your self-calibrating
joysticks (controls 1 … 4) are not exactly 0 % of
their control travel, then this can be checked and, if
necessary, corrected as follows.
Jump to the »Model select« menu and initialize
a free model memory as described on page 69.
Whether the model to be initialized is a winged
aircraft or a helicopter is irrelevant.
Wait for the notices which typically appear in the
transmitter's base screen following a model change
then jump to the »Servo display« menu, for example
by simultaneously touching the ef keys of the left
touch pad (WITHOUT any interim changes to trim
settings or other program settings).
If all four of your transmitter's joystick functions are
still self-neutralizing, this display should ideally look
like the one shown below.
1
3
5
7
9
11
13
15
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
2
4
6
8
10
12
14
16
Otherwise the graph bars show current setting
percentages for joystick control functions which are
not self-neutralizing – typically for the "C1" throttle/
brake or throttle/pitch joystick. For example, if the
throttle/brake joystick is in its "quarter-throttle"
position, the display would appear as shown below.
1
3
5
7
9
11
13
15
0
0
0
0
0
0
0
0
–50
0
0
0
0
0
0
0
2
4
6
8
10
12
14
16
One after the other, put both joysticks into each
of their four possible limit positions without
exerting force at the limit position. In each of
these eight possible limit positions, the – side
dependent – indication for exactly -100 % or +100 %
should be displayed. For example, if transmitter
control 2 is at its right limit and the other three joystick
functions are in their respective middle positions
then the transmitter's display should look like the one
shown below.
To Next Page
Loading...
Need help?
General
