207
Detail program description - Dual mixers
Diff.
DUAL MIXER
Mixer 1
Mixer 2
8
RU
Mixer 3
Mixer 4
??
??
??
??
??
??
+75%
0%
0%
0%
When a rudder command is given, the second servo
connected to output 8 follows suit. (With this type of
programming, differential travel can be confi gured
for the rudders.) In this case, too, trim from the
rudder stick affects both servos. If the rudders are
also required to defl ect outwards when the airbrakes
are activated, then you should assign the C1 stick
(transmitter control 1) to input 8 on the »Control
adjust«" menu. Afterwards, change to the "Offset"
column then modify the offset value until both
rudders are again in their neutral positions. It may
be necessary to "play" a bit with the offset and travel
adjustments.
To Next Page
Loading...
Need help?
General
