252 Detail program description - Ring limiter
In practice, the setting is made by changing the given
value until the respective servos in the model just
reach the point where they no longer move.
A tap on the cd or ef keys of the right touch pad at
the same time (CLEAR) will reset the changed value in
the active value fi eld back to its "100 %" default value.
In the next line down – labeled at the bottom left of
the display as " <=> -X" or " <=> -Y", depending
on the position of the marker frame – the setting
values, in a range from 0 % and a maximum of 125 %,
affect the form of limitation between "circular" and
"rectangular", whereby a setting value here may
never be greater than the value of the fi eld above it.
Ring Limit 1
0%
100%
CH 4
VSP OUT X
VSP OUT Y
0%
0%
100%
{–X
0%
CH 3
Ring Limit 1
0%
100%
CH 4
VSP OUT X
VSP OUT Y
0%
0%
100%
{–X
100%
CH 3
A tap on the cd or ef keys of the right touch pad at
the same time (CLEAR) will reset the changed value
in the active value fi eld back to its "0 %" default value.
When fi nished with these settings, switch back to
the fi rst display page for this option then repeat this
procedure, as applicable, for the lines of ring limiter
2 or 3.
Final note:
This option can, of course, also be used as necessary
and applicable for fi xed-wing models.
To Next Page
Loading...
Need help?
General
