GRAUPNER MC-20 HoTT User Manual

267
Detail program description - Info display
Time
RFID
Firmware Version
date
time
SD-CARD
1.234
ABCDEF12
2011/11/11(Fr )
11:22:33s
1943MB
If necessary, select this line with the selection keys
of the left or right touch pad and, as applicable, the
minute fi eld. After activation of the respective value
fi eld by a tap on the center
SET key of the right touch
pad, the hour or minute can be adjusted with the
selection keys of the right touch pad. Another tap on
the center
SET key of the right touch pad will close
the given entry.
In contrast, the seconds display cannot be set
directly; it can only be restarted at "00" with a brief
tap on the center
SET key of the right touch pad.
Note:
If the transmitter is connected to a PC as •
described on page 43, the date and time can
also be set through the PC program provided for
the respective product via the Internet page at
www.graupner.de.
The date and time are protected against data •
loss due to power failure by a buffer battery for
situations like a battery change, see page 18.
SD card
RFID
Firmware Version
date
time
SD-CARD
1.234
ABCDEF12
2011/11/11(Fr )
11:22:33s
1943MB
In this line the memory capacity of a memory card
inserted in the transmitter, if applicable, is shown
in MB.
Depending on the memory capacity of the inserted
micro SD or micro SDHC memory card, it may take
several minutes until the correct value is shown after
switching on the transmitter.
available
Firmware Version
date
time
SD-CARD
1.234
2011/11/11(Fr )
11:22:33s
1943MB
available
1933MB
Display of the available storage space in MB.
As mentioned before, display of the available storage
space – depending on the capacity of the inserted
memory card – does not appear until some time has
passed after switching on the transmitter.
The display of the available storage space in relation
to the total memory capacity is shown in the line
below:
date
time
SD-CARD
2011/11/11(Fr )
11:22:33s
1943MB
available
1933MB
99%
As mentioned before, display of the available storage
space – depending on the capacity of the inserted
memory card – does not appear until some time has
passed after switching on the transmitter.

GRAUPNER MC-20 HoTT Specifications

General

Brand	GRAUPNER
Model	MC-20 HoTT
Category	Remote Control
Language	English