Check Check
Touch
Touch
Touch
Touch
Touch
Touch
Check Check
Touch
10
1-3. INT.M (Internal Model)
It is used to copy the model memory in SD Card into the model list of transmitter. To make use of
INT.M function, you need SD Card that has the programmed model le. If you put SD Card into SD
Card slot on the back of transmitter, “SD Card” icon is lighted in the transmitter main page. When
the icon is lighted, touch the base setup icon to call the base setup page. In the page, touch “Mod-
el Select” icon to call the “Model Sel” setup page and touch the copy destination then it is activated
in blue. Touch “INT.M” icon then the model list in SD Card appears and then select the source
model to copy. The popup message indicating the destination and source appears. Touch YES, if
they are correct, then “Please wait” message is displayed and a few seconds later, the model data
in SD Card is copied to the model list in transmitter.
1-4. EXT.M (External Model)
This function is used to copy the model in transmitter into SD Card. In order to use EXT.M
function, you need to plug SD Card into SD Card slot on the back of transmitter. When it is
plugged into the slot, “SD Card” icon is lightened in the transmitter main page. Touch Base
setup icon to call the base setup page. In the page, touch “Model Select” icon to call the “Mod-
el Select” setup page and touch the source model to copy in transmitter then it is activated in
blue. Touch “EXT.M” icon then the popup message “SD Card EXPORT?” appears. Touch YES
then “Please wait” message is displayed and a few seconds later, the model data in transmitter
is copied to SD Card now
To Next Page
Loading...
Need help?
General
