Touch
Touch
Touch
YES YES
MODEL
CHANGE
MODEL
CHANGE
NO NO
Touch
6
1. Model select
It is used to add or select model.
Touch Model Sel icon in base menu to access Model sel menu
1-1. SET
Touch and activate “MODEL NAME” icon in blue for your purpose and touch SEL icon. Select YES
in “MODEL CHANGE” pop up then another pop up “Please Wait !!” appears. About 1 sec later, the
selected MODEL NAME appears at the top on the screen
1-2. NEW
This function is use to create the new model or exchange the current model to others. There is
2 methods of Manual setting and Wizard setting. You may program the basic function sequen-
tially in Manual setting. Here is the example for airplane
Touch the desired MODEL NAME icon and touch NEW icon on the right then the pop up
message “ Select” appears. Touch MAN to start Manual setting. The rst function of Manual
setting is MODEL NAME. Tap model name in blank of New Model Name using keypad on the
right. Touch EN icon on the right bottom and touch MAN icon on the left top then the model is
named and stored and then the next function, model type, is accessed.
• Alphabet keyboard explanation.
- CL(Clear):it is used to erase every letter you typed at a time.
- SP(SPACE):it is used to make a space between words
- DE(DELETE):it is used to erase a letter you typed
- EN(ENTER):it is used to save every letter you typed.
- CAPS:it is used for capital letters or small letters
- NUM:it is used for numbers.
- SPECIAL:it is used for special character.
In accordance with model type that you selected, swash type function or wing type function
is accessed. Below picture shows the example for wing type in airplane. Select the desired
wing type, tail type and power type in turn. If all procedures have been done correctly, all types
that you selected appear on the page. Touch ENT icon on the right bottom after checking the
selected types, Manual setup is completed and returned to base menu
BASE MENU (Helicopter, Airplane, Gilder)
To Next Page
Loading...
Need help?
General
