Touch
Touch
Touch
Touch
Touch Touch
15
6. THR.CUT
This function is used to stop the operation of engine. THR.CUT function works from below one-
third position of the full movement range of throttle stick. Touch “THR.CUT” icon in the base menu
page to call the “THR.CUT” setup page. When touching “INH” icon in “ACT” line, you may change
the value to “OFF”. When touching “On” icon in “CTL”, the message “Select” is popped up. Now,
move the switch with your choice then this switch is set to on/ off switch for “THR.CUT” and the
switch setup page appears. You may change ON/OFF by touching icons. When the switch is
moved to the direction of ON, the function is operated. After the switch setup is completed, touch
“BACK” icon on the left top to return “THR.CUT” setup page then set the value in “SET” line. Touch
“017%” icon to activate it in blue and touch “INC” and “DEC” icons to decide the throttle position
when “THR.CUT” is on. Now the servo of throttle channel is operated to the corresponding posi-
tion. Touch “Back” icon to return the base menu page.
Touch
Touch
Touch
Touch
Touch
To Next Page
Loading...
Need help?
General
