85
Touch
Touch
Touch Touch
Touch
Touch
Telemetry
Touch Touch
9. Flap MIX
It consists of 4 mixing types, “FLAP”, ”AILE>>FLAP”, “ELEV>>FLAP”, and “FLAP>>ELEV”.
All of 4 mixing types are closely related with Q.LINK setup and the different values can be set to
each individual Q.Link for 4 mixing types
9-1. FLAP
This function is used to adjust the ap angle to increase or decrease airplane lift
To setup the ap function, you need to designate on/off control key such as switch, stick and
volume. When you move the control key, the ap function is operated.
Touch “CH SET” in BASE page to call “CH SET” setup page. Touch “NONE” icon in FLAP 1 line to
pop up “Select” message. Move the control key with your choice then that control key is designat-
ed as on/ off key. Now, touch “SERVO” icon in the right top to call the servo view page. The default
value, 30%, for the travel amount of servo is displayed in the graph and this function value can be
adjusted. To adjust the function value, touch “Flap MIX” icon in the function page to call Flap Mix
page and touch “>>” icon in SET line to call the ap setup page. Touch and activate the function
value to adjust with INC and DEC buttons and touch “SERVO” icon again to call the servo view
page. Now, if you move the control key, you may check the setup value of servo in this page. After
setup, touch “BACK” icon to return to Flap MIX page.
REFERENCE: You may use Flap function without designating control key using OFFSET function
at the ap setup page. But the delicate ap operation is impossible.
Telemetry
Touch
Touch
To Next Page
Loading...
Need help?
General
