To Next Page

To Previous Page

Touch

- RANGE TEST

“Range Test” function reduces the power output. This allows for a range test to conrm the RF link

is operating correctly. Perform a range check at the beginning of each ying session to conrm

system operation.

If the servo connected to receiver is operated normally within 50m or 70m of the distance from the

receiver, you may y a model, if not, you need do range test again. If it doesn’t operate normally

even after the test, please send mz-12 for repair.

Touch “OFF” icon in “RANGE TEST” to change to “ON”, transmitter beeps indicating “Range test”

setup begins. This function is available for 99sec. you may touch “ON” icon if you want to stop the

function.

- DSC OUTPUT

It is used to set the number of channel when Trainer function is used with DSC jack. If 5 channels

are used, PPM5 is recommended to use. To use more than 5 channels, choose the appropriate

PPM for each condition. PPM10, PPM16, PPM18, PPM24 are selectable.

Whenever you touch the value icon in DSC OUTPUT, You can select “PPM10”, “PPM16”,

“PPM18”, and “PPM 24” in turn. Default value is “PPM 10”.

8. TIMER

Timer function may be set for any desired time ,i.e. model time, date, time, etc. Two independ-

ent timers, TIMER1 and TIMER2, are provided for each model. Touch “Timer” icon in base

menu page to call the timer setup page.

Touch

GRAUPNER mz-24 HOTT Operating Instructions

Other manuals for GRAUPNER mz-24 HOTT