Touch Touch
Touch
Touch
Touch
19
Touch the value in “MODE” line to select “UP” or “DOWN”. Timer may be counted down or
counted up with your choice. Count-up timer is to count from zero to the setup time and Count-
down timer is to count from the setup time to zero.
After “MODE” setup, you need to set “ALARM”. The alarm sounds from the last 20 seconds in the
setup time. The rst 10 seconds, it sounds at intervals of 2 seconds and the next 10 seconds, it
sounds at interval of 1 second.
After “ALARM” setup, you may set “START SW”. Touch “NULL” icon in “START SW” to call “Select”
message popup. Now, move the switch with your choice then this switch is set on/ off switch for
“START SW” and the switch direction setup page appears. You may change ON/OFF by touching
icons. When the switch is moved to the direction of on, the function is operated. Touch “Back” icon
to return TIMER setup page
Timer consists of TIMER1 and TIMER2. The ight data is saved to SD card on transmitter
during the ight time is operating in TIMER1 mode but TIMER2 don’t have the storing function
for the ight data.
The timer in the rst page is the ight time setup line. Touch the value in minute or second to
operate and stop timer and touch “T.RES” icon to reset the ight time
Touch Touch
To Next Page
Loading...
Need help?
General
