To Next Page

To Previous Page

Touch

1-2 NAM

It is used when to revise the name of “Q.LINK”. Touch the target value in “Q.LINK” to activate

in blue. Now touch “NAM” icon to call NAM setup page. In the page, enter the desired name

using the keypad. After that, touch “EN” icon then the revised name is displayed in “New

Q.LINK Name”. Now, touch “BACK” icon on the left top left to call “Q.LINK” setup page and the

revised name is stored at the corresponding Q.LINK.

1-3 CPY

mz-24 supports copying the preset Q.LINK setup data into another Q.LINK. Touch and activate the

source Q.LINK in blue and touch “CPY” icon to call “COPY” message popup. Whenever touching

Q.LINK in TARGET line in the popup, all entries in TARGET are displayed in turn. Now, select the

target Q.LINK and touch “YES” icon then the source data is copied into the target Q.LINK. Now,

return to Q.LINK setup page.

Touch Touch

Touch

GRAUPNER mz-24 HOTT Operating Instructions

Other manuals for GRAUPNER mz-24 HOTT