To Next Page

To Previous Page

Touch

9. FAILSAFE

When you bind your transmitter, you are programming the receiver with failsafe defaults. If

connection is lost between the transmitter and receiver, the receiver immediately operates in

those preprogrammed default positions.

The default value is “Hold” and you may select “Hold” or ”F/S” for up to six channels.

CAUTION: Fail safe function should be operated when the transmitter and receiver are

switched on.

• Hold: If you lose connection between the transmitter and the receiver, the preset channels

hold the last given command.

• F/S: If the signal is lost, the preset channels are driven to their failsafe preset position.

In the base page, touch “Fail Safe” icon to call “Fail Safe” setup page. All channels’ default

values excepting for throttle channel are set in “Hold”. Touch “Hold” icon in the channel to set

to “F/S” and then touch the “SET” value to activate in blue. After that, move transmitter stick

to the desired position and touch “Set” icon in the right bottom then the position of transmitter

stick is displayed in percentage. Every channel can be set in the same and when touching

NEXT icon in the right, you may call the next setup page.

You may set “Delay” function after all channels setup, 0.25s is set by default, and may select

any of 3 types ( 0.5s, 0.75s, 1.0s ) by touching the delay mode icon. After “Delay” setup, be

sure to touch “STO1” and “STO2” icons in the right to transmit Failsafe setup data to a receiv-

er. Now failsafe setup is completed.

GRAUPNER mz-24 HOTT Operating Instructions

Other manuals for GRAUPNER mz-24 HOTT