To Next Page

To Previous Page

Touch

14-3. SENSOR SELECT

This function is used to program telemetry sensor that is connected to HoTT receiver.

You should select the sensor rst to use and program the function such as voice function,

warning and the telemetry data information.

Touch “>>” icon in SENSOR SELECT line then RECEIVER, GENERAL MODULE, ELECTRIC

AIR, MOD, VARIO MODULE, GPS, and ESC are displayed. RECEIVER is set to ON, the

others are set to OFF by default.

To select the sensor, touch “OFF” icon to switch to “ON” then voice function, warning and the

telemetry data information are available. After the sensor selection is completed, touch “BACK”

icon to return to the previous page.

Touch

GRAUPNER mz-24 HOTT Operating Instructions

Other manuals for GRAUPNER mz-24 HOTT