Touch
Touch
Touch Touch
Touch
Touch
Touch
Touch
Touch
Touch
14
5. Sub-Trim
It is used to set the servo neutral position, and may be used to make ne adjustments to
control surface without hooking linkages and pushrods up. The trim for transmitter stick should
be in center position at the rst and then Sub-Trim should be set. Touch “Sub-Trim” icon in the
base menu to call the “Sub-Trim” setup page. In the setup page, touch “000%” icon to activate
in blue. “Sub-Trim” values can be adjusted with the “INC”, “DEC” icons. When the setting for
“Sub-Trim” is completed, touch “Servo” icon to call “Servo View” page in which you may check
“Sub-Trim” value in a graph. Touch “Back” icon to call “Sub-Trim” setup page and touch “Back”
icon again to call “Base” menu page after setting “Sub-Trim” for every channel.
4. Reverse
It is used to reverse the operation of an individual servo. Touch the “Reverse” icon in the base
menu page to call the Reverse setup page. In “Reverse” page, you are able to reverse the oper-
ation of a servo. When you touch the “NOR” icon, “NOR” is changed to REV” and the operation
of an individual servo is reversed. Touch “Servo” icon on the left top to call the “Servo View” page
after setting “Reverse” function. When each channel’s stick is controlled, “Reverse” setting status
can be seen in a graph. Now, touch “Back” icon in the servo view page to call the reverse setup
page. When Reverse function setting is completed, touch “Back” icon on the top left page to call
the Base menu page.
To Next Page
Loading...
Need help?
General
