GRAUPNER mz-24 HOTT

51
Touch
Touch
Touch
Touch
Touch
Touch
Touch
Telemetry
14. Telemetry
It is used to perform the programming setup and check HoTT telemetry functions. Touch “Teleme-
try” icon to call the Telemetry page. You may program 5 types of “RX SELECT”, “SETTING & DATA
VIEW” “SENSOR SELECT”, ”RF STATUS VIEW”, and “VOCIE TRIGGER”.
14-1. RX SELECT
It is used to select a receiver that would transmit the telemetry data to mz-12 when 2 receivers are
bound to mz-12. All of the telemetry sensors should be connected to the selected receiver. RX1” is
set in RX SELECT line as a default and “RX1” and “RX2” can be switch by touching.
Telemetry
Touch
Touch
14-2. SETTING & DATA VIEW
It is used to program or check telemetry data of a receiver and telemetry sensors. Only if
transmitter and receiver are bound, SETTING & DATA VIEW function is activated. Touch “>>”
icon in the telemetry setup page to call “RX DATA VIEW” setup page
- RX DATA VIEW
You may check telemetry data of a receiver in this page. Touch “ENT” icon to access to the
next function, “RX SERVO” page.