To Next Page

To Previous Page

Touch

14-4. RF STATUS VIEW

It shows RF status between transmitter and receiver throughout telemetry function

Touch “>>” icon in RF STATUS VIEW line then the indication to show the RF connection status is

displayed by graph.

14-5. VOCIE TRIGGER

It is used to program the sensors related with voice function. REPEAT, TRIG, VARIO, TRANSS-

MITTER, RECEIVER are available by default and the optional sensors could be attached. If the

optional sensor is connected, it is need to add the optional sensor at SENSOR SELECT mode

then new category in VOICE TRIGGER is created. The useable sensors are GENERAL MODULE,

ELECTRIC AIR MODULE, VARIO MODULE, GPS, AIR ESC

Touch “>>” icon in VOICE TRIGGER line to call “VOICE TRIGGER” setup page.

- REPEAT

You may set the time and designated the transmitter control for one of voice functions. If the

control is on, that voice functions is repeated for the setup time.

Touch the value, “01s”, in blue and adjust the repeat time with INC and DEC buttons. Touch

“NULL” icon to call the “Select” message popup. Move the switch or volume with your choice then

that switch or volume is designated as on/ off key and then the key direction setup page appears.

You may select ON or OFF by touching icons. When the key is moved to the direction of ON, the

function is operated. Touch “BACK” icon to return to “VOICE TRIGGER” setup page.

GRAUPNER mz-24 HOTT Operating Instructions

Other manuals for GRAUPNER mz-24 HOTT