Gravotech M20 - X84; Electromagnetic Compatibility

29
M_M20 series V3_EN_C
Recommendations for installation
• Avoid the installation of manual or automatic switching systems on the same mains power line as the
machine(relays,timers,programmers,automaticcircuit-breakers,automaticswitches,etc.).
• Checkthat devices in the vicinity ofthemachine meet the standards forelectromagneticinterference.
Read the technical data sheet for each device. If they are non-compliant, move them as far away from the
machine as possible.
• Use the Gravotech accessories.
Alwaysswitchthemachineo󰓐beforeconnectingordisconnectingacableor
optional accessory.
 Electromagnetic compatibility
FCC Rules - For USA and Canada only
CAUTION:Changesormodi󰄈cationsnotexpresslyapprovedbythepartyresponsibleforcompliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception which can be determined by
turningtheequipmento󰘯andon,theuserisencouragedtotrytocorrectinterferencebyoneormoreofthe
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connecttheequipmentintoanoutletoncircuitdi󰘯erentfromthattowhichthereceiverisconnected.
• Consult the dealer or an experienced radio/TV technician for help.