Gravotech M20 - Installation; X84; Switching on the Machine; X84; Power down; X84; Restarting

31
M_M20 series V3_EN_C
Connections - Installation
3. Installation
 Switching on the machine
1. Machine:Placetheswitchinthe"I"position(On).
The machine emits an audible signal.
The power LED lights up.
Leave the machine powered on, even if it is only going to be used at intervals.
 Power down
1. Setthegeneralstopbuttontothe"O"(Stop)position.
Switcho󰘯themachineinthefollowingsituations:
• when the operator is permanently leaving the machine
• in the event of physical damage (something is dropped on the machine, 󰘰re, a liquid is spilled on the
machine, etc.)
• mechanical/electrical/electronicfaultssuggestingabreakdown
• if there is a major problem or the machine is jammed mechanically
• themachineisjammedontheparttobeengraved/marked
• themachineisjammedonanobjectintheworkarea
• forced restart
• external/internal cleaning
 Restarting
Ifthemachineortheoperatingprogramlocks,themachinemayneedtoberestarted.
1. Switcho󰓐themachine.
2. Wait approximately 30 s.
Thiswaitingtimemustberespected.Itpreventsanelectricsurgelikelytodamagethemachine'spowersupply.
3. Switch on the machine.
 Program installation
Refer to the user manual for the program.