Gravotech M20 - Preventive Maintenance; General Machine Cleaning

70
M_M20 series V3_EN_C
M. Preventive maintenance
1. General maintenance
Unplug the power supply plug before beginning any cleaning or maintenance
operation.
The mains power cable must be replaced immediately if it is cut or crushed, cracked
or a conductor is stripped bare.
The machine's maintenance needs depend on the type of material used, the quantity of material removed,
frequency of operation, environment and the e󰘯ectiveness of the air extraction system. It is the user's
responsibilitytode󰘰nethem.
Dust and debris that accumulate on the machine's components can cause irregular or imprecise engraving, or
the loss of the engraving position and the premature failure of components.
Regularlycleaningthemachineimprovesitsoperation,extendsthelifeofpartsandreducestheriskoffailure.
Recommendations:Checkand,ifnecessary,cleanthemachineevery8hoursofengraving/markingorcutting.
For help, contact Gravotech.
No internal parts of the machine require user intervention. Routine maintenance only involves external cleaning
of the engraving area.
To clean other parts of the machine, call a Gravotech technician.
2. Adjusting the machine
The center of the engraving area of the machine must be aligned with the clamping system.
The M20 series machines have a machine reference point adjustment system which can be deployed by the
user.
Adjust these settings every 3 months or whenever the machine has been moved.