Gree U-Match 5 Series - Page 144

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
141
Removal of fan and motor
Note: Before removing the motor, power must be cut off.
Step Picture Work instruction
4. Remove the fan.
 Use a screwdriver to remove the
clamping band of motor. Then
remove the fan.
5. Remove motor.
 Use a screwdriver to unscrew
the 4 screws of motor. Then
remove the motor.
6. Replace and install the
motor.
 Remove the motor from motor
support and then replace with a
new motor.
 Tighten the 4 screws of motor
with a screwdriver.
7. Install the fan.
 Direct the hole of fan to the
motor shaft and then mount on
the fan.
 Tighten the clamping band of
motor with a wrench.