Gree U-Match 5 Series - Page 145

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
142
Removal of fan and motor
Note: Before removing the motor, power must be cut off.
Step Picture Work instruction
8. Install the water tray.
 Direct the 4 corners of water
tray to the 4 corners of the unit
and then press them. Use a
screwdriver to tighten the
screws in the 4 corners.
 Connect the power cord and
water pump wire.
 Place back the cover of electric
box and the clamp of power
cord. Then tighten the screws
with a screwdriver.
Removal and installation of drain pump
Step Picture Work instruction
1. After removing the front
panel as instructed above,
loosen the screws of the
water tray.
 Use a screwdriver to loosen the
screws of water tray.
2. Remove the cover of
electric box and the clamp
of power cord.
 Twist off the screws and open
the cover of electric box and the
clamp of power cord.
3. Remove the motor wire and
water pump wire.
 Remove the motor wire and
water pump wire in the electric
box.
4. Remove the water tray.
 Loosen the screws in the 4
corners and then remove the
water tray.