Gree U-Match 5 Series - Page 146

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
143
Removal and installation of drain pump
Step Picture Work instruction
5. Remove the drain pipe and
loosen the screws of water
pump.
 Take out the drain pipe and use
a screwdriver to loosen the
screws of water pump.
6. Remove and replace the
pump.
 Remove the pump and replace
with a new one.
7. Connect the drain pipe and
tighten the screws of water
pump.
 Connect the drain pipe and
tighten the screws of water
pump.
8. Install the water tray and
tighten the screws.
 Direct the 4 corners of the water
tray to the 4 corners of the unit
and press them. Then use a
screwdriver to tighten the
screws.
9. Connect the water pump
wire and power cord, and
then put back the cover of
electric box and the clamp
of power cord.
 Connect the water pump wire
and motor wire according to the
wiring diagram.
 Put back the cover of electric
box and the clamp of power
cord. Then tighten the screws.