Grizzly G0824 User Manual

-8-
Model G0824 (Mfd. Since 12/16)
The information contained herein is deemed accurate as of 5/5/2019 and represents our most recent product specifications.
Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased.
PAGE 2 OF 3
Model G0824
Main Specifications:
Operation Info
Swing Over Bed......................................................................................................................................... 14 in.
Distance Between Centers........................................................................................................................ 40 in.
Swing Over Cross Slide..................................................................................................................... 8-13/16 in.
Swing Over Saddle.......................................................................................................................... 13-13/16 in.
Swing Over Gap.................................................................................................................................. 19-3/4 in.
Maximum Tool Bit Size............................................................................................................................. 5/8 in.
Compound Travel.................................................................................................................................. 3-7/8 in.
Carriage Travel.......................................................................................................................................... 36 in.
Cross Slide Travel............................................................................................................................. 6-11/16 in.
Headstock Info
Spindle Bore.............................................................................................................................. 2.01 in. (51mm)
Spindle Taper............................................................................................................................................ MT#6
Number of Spindle Speeds............................................................................................................................... 8
Spindle Speeds......................................................................................................................... 70 – 2000 RPM
Spindle Type................................................................................................................................ D1-5 Camlock
Spindle Bearings................................................................................................ High-Precision Tapered Roller
Spindle Length..................................................................................................................................... 17-1/4 in.
Spindle Length with 3-Jaw Chuck.............................................................................................................. 22 in.
Spindle Length with 4-Jaw Chuck....................................................................................................... 21-1/2 in.
Spindle Length with Faceplate............................................................................................................ 20-1/2 in.
Tailstock Info
Tailstock Quill Travel......................................................................................................................... 3-15/16 in.
Tailstock Taper.......................................................................................................................................... MT#3
Tailstock Barrel Diameter.................................................................................................................. 1-21/32 in.
Threading Info
Number of Longitudinal Feeds....................................................................................................................... 32
Range of Longitudinal Feeds.......................................................................................... 0.002 – 0.0548 in./rev.
Number of Cross Feeds................................................................................................................................. 32
Range of Cross Feeds.................................................................................................. 0.0007 – 0.0187 in./rev.
Number of Inch Threads................................................................................................................................. 34
Range of Inch Threads...................................................................................................................... 4 – 56 TPI
Number of Metric Threads.............................................................................................................................. 26
Range of Metric Threads.................................................................................................................. 0.4 – 7 mm
Dimensions
Bed Width.............................................................................................................................................. 7-3/8 in.
Carriage Leadscrew Diameter.................................................................................................................. 7/8 in.
Leadscrew TPI........................................................................................................................................... 8 TPI
Carriage Leadscrew Length....................................................................................................................... 50 in.
Steady Rest Capacity................................................................................................................... 3/8 – 2-3/4 in.
Follow Rest Capacity.................................................................................................................... 3/8 – 2-3/8 in.
Faceplate Size........................................................................................................................................... 11 in.
Feed Rod Diameter.................................................................................................................................. 3/4 in.
Floor to Center Height......................................................................................................................... 45-1/2 in.
Construction
Headstock............................................................................................................................................ Cast Iron
End Gears...................................................................................................................... Flame-Hardened Steel
Bed...................................................................................................................... Induction-Hardened Cast Iron
Body..................................................................................................................................................... Cast Iron
Stand.......................................................................................................................................................... Steel
Paint Type/Finish...................................................................................................................................... Epoxy

Grizzly G0824 Specifications

General

Brand	Grizzly
Model	G0824
Category	Lathe
Language	English