Grundfos TPE2 - Base Plate; Insulation; Frost Protection; Cable Entries

TM060724
Positioning of clamp ring
Related information
5.2 Battery
8.4 Base plate
Twin-head pumps have tapped holes in the bottom of
the pump housing. You can use the holes for
mounting a base plate.
8.5 Insulation
Do not insulate the motor stool as this will
trap any vapour escaping from the shaft
seal, thus causing corrosion. Covering the
motor stool with insulation will also make
inspection and service difficult.
Follow the guidelines in figure below when insulating
the pump.
A
B
C
TM057918
Insulation of TPE2, TPE3 pumps
Pos. Description
A Without insulation
B Correct insulation
C Incorrect insulation
8.6 Frost protection
Drain pumps which are not being used during periods
of frost to avoid damage.
8.7
Cable entries
See the size of the cable entries in the section on
other technical data.
Related information
34. Other technical data
16
English (GB)