Grundfos TPE2 - Set Manual Speed; User-Defined Speed; Control Mode

All operating modes are illustrated in the figure below.
Q
H
Max.
3
1
2
Min.
Stop
TM064024
Operating modes
Pos. Description
1 Normal
2 Normal
3 Manual
Factory setting
See section Factory settings.
Related information
17.4 Set manual speed
17.5 User-defined speed
35. Factory settings
17.4
Set manual speed
Pump variant Set manual speed
TPE3, TPE3 D ●
TPE2, TPE2 D ●
This menu is only available in the advanced control
panel. With Grundfos GO, you set the speed via the
Setpoint menu.
You can set the pump speed in % of the maximum
speed. When you have set the operating mode to
Manual, the pump starts running at the set speed.
The speed can then be changed manually via
Grundfos GO or via the advanced control panel.
Factory setting
See section Factory settings.
Related information
35. Factory settings
17.5
User-defined speed
Use this function to set the motor speed in
percentage of the maximum speed. When you have
set the operating mode to User-defined speed, the
pump starts running at the set speed.
17.6 Control mode
Pump variant "Control mode"
TPE3, TPE3 D ●
TPE2, TPE2 D ●
Possible control modes:
• "AUTOADAPT"
• "FLOWADAPT"
• Prop. pressure (proportional pressure)
• Const. pressure (constant pressure)
• Const. temp. (constant temperature)
• Con. diff. press. (constant differential pressure)
• Con. diff. temp. (constant differential
temperature)
• Const. flow rate (constant flow rate)
• Const. level (constant level)
• Const. other val. (constant other value)
• Const. curve (constant curve).
Set the operating mode to Normal before
you enable a control mode.
You can change the setpoint for all control modes,
except AUTOADAPT and FLOWADAPT, in the
Setpoint submenu under Settings when you have
selected the desired control mode.
Factory setting
See section Factory settings.
Related information
35. Factory settings
43
English (GB)