Grundfos TPE2 - Run Start-Up Guide; Alarm Log; Warning Log; Assist

17.42 Run start-up guide
Pump variant Run start-up guide
TPE3, TPE3 D ●
TPE2, TPE2 D ●
This menu is only available in the advanced control
panel.
The startup guide automatically starts when you start
the pump for the first time.
You can always run the startup guide later via this
menu.
The startup guide guides you through the general
settings of the pump.
• Language. See section Language.
• Select date format.*
See section "Date and time" (Set date and time).
• Set date.*
See section "Date and time" (Set date and time).
• Select time format.*
See section "Date and time" (Set date and time).
• Set time.*
See section "Date and time" (Set date and time).
• Setting of pump
- Go to Home.
- Run with Constant curve/Run with
Constant pressure.
See section Control mode.
- Go to "Assisted pump setup".
See section Assisted pump setup.
- Return to factory settings.
* Applies only for pumps with advanced functional
module, FM 300. For further information, see section
Identification of functional module.
Related information
17.6 Control mode
17.30 Language
17.31 Date and time (Set date and time)
24. Identification of functional module
17.43
Alarm log
Pump variant Alarm log
TPE3, TPE3 D ●
TPE2, TPE2 D ●
This menu contains a list of logged alarms from the
product. The log shows the name of the alarm, when
the alarm occurred and when it was reset.
17.44 Warning log
Pump variant Warning log
TPE3, TPE3 D ●
TPE2, TPE2 D ●
This menu contains a list of logged warnings from the
product. The log shows the name of the warning,
when the warning occurred and when it was reset.
17.45 Assist
Pump variant Assist
TPE3, TPE3 D ●
TPE2, TPE2 D ●
The menu consist of functions which take you through
the steps needed to set the pump.
74
English (GB)