Grundfos TPE2 - Page 36

Settings
TPE3
TPE3 D
TPE2
TPE2 D
Multipump
system
Section
Digital inputs ● ● ●
Digital inputsDigital input 1, setup ● ● ●
Digital input 2, setup ● ● ●
Digital inputs/outputs ● ● ●
Digital inputs/outputs
Digital input/output 3,
setup
● ● ●
Digital input/output 4,
setup
● ● ●
Relay outputs ● ● ●
"Signal relays 1 and 2"
(Relay outputs)
Relay output 1 ● ● ●
Relay output 2 ● ● ●
Analog output ● ● ●
Analog output
Output signal ● ● ●
Function of analog output ● ● ●
"Controller settings" ● ● ●
Controller (Controller
settings)
Operating range ● ● ● Operating range
Setpoint influence ● ● ●
External setpoint function ● ● ● External setpoint function
"Predefined setpoints" ● ● ● Predefined setpoints
Temperature influence ● - ● Temperature influence
Monitoring functions ● ● ●
Motor bearing monitoring ● ● ● Motor bearing monitoring
Motor bearing
maintenance
● ● ●
Limit-exceeded function ● ● ● Limit-exceeded function
"Special functions" ● ● ●
"Pulse flowmeter setup" ● ● ● Pulse flowmeter setup
"Ramps" ● ● ● Ramps
"Standstill heating" ● ● ● Standstill heating
Communication ● ● ●
Pump number ● ● ● Number (Pump number)
Enable/disable radio
comm.
● ● ●
Radio communication
(Enable/disable radio
comm.)
General settings ● ● ●
Language ● ● ● Language
Set date and time ● ● ●
Date and time (Set date and
time)
Units ● ● ● Unit configuration (Units)
36
English (GB)