GUDEL FlexxPump4 D - Decommissioning and Storage; Decommissioning and Storage Introduction; Product Storage Conditions

9 Decommissioning, storage
9.1 Introduction
Only perform the tasks described in this chapter after you have read and un-
derstood the chapter "Safety". Ü215
It concerns your personal safety!
9.1.1 Personnel qualifications
Only appropriately trained and authorized technicians are allowed to work on
the product.
9.2 Storage conditions
DANGER
Leaking fluids
Oils, greases and other operating consumables may leak during the entire
service life of the product. These leaking liquids are harmful to the environ-
ment!
• Observe the specified maintenance intervals and service intervals
• When anchoring the product, ensure that the boreholes are drilled cor-
rectly
• The oils and greases must not get into the drinking water supply. Take ap-
propriate measures
• Observe the country-specific safety data sheets
• Oils and greases must be disposed of as hazardous waste, even if the total
quantity is small
Room
Store the product in a dry location. For information on the required space
and the floor capacity, refer to the layout. Use a covering to protect the
product against dust and dirt.
Decommissioning, storage
OPERATING MANUAL Lubrication system
FlexxPump4D
9007202674126091_v2.0_EN-US
107