GUDEL FlexxPump4 D - Danger Areas and Safety Equipment

2.3 Danger areas
The danger area is the area at a product and/or in its surroundings where
there is a potential of danger to the life or health of persons, or to the envi-
ronment, or damage to property. The operator must secure the danger area
(protective fence/sensors). No person is allowed access to the danger area.
All safety provisions and hazard symbols at the product must be obeyed. The
general safety provisions must be observed and complied with.
2.3.1 Safety and monitoring equipment
DANGER
Missing safety and monitoring equipment
Missing or changed safety and monitoring equipment could lead to serious or
fatal injuries!
• Do not dismantle, bridge, or change any safety or monitoring equipment
• After commissioning, attach all safety and monitoring equipment correctly
• Ensure that the safety and monitoring equipment is closed during opera-
tion
You will find information on the separating safety and monitoring equipment
in the documentation of the entire plant.
The operator is responsible for ensuring safe conditions in the vicinity of the
product. In particular, he must ensure compliance with the general safety reg-
ulations, guidelines and standards. Before commissioning, the operator must
check if all the safety measures have been met. They must cover all hazards.
This is the only way to ensure that application of the product conforms to CE
regulations.
According to the machinery directive, the safety and monitoring equipment
must:
• Correspond to best practices
• Comply with the required safety category
Safety
OPERATING MANUAL Lubrication system
FlexxPump4D
9007202674126091_v2.0_EN-US
17