H3C S5500-EI Series - Page 7

Quick Start
H3C S5500-EI Series Ethernet Switches
Table of Contents
ii
3.1.2 Introduction to Guide Rails ......................................3-4
3.1.3 Using Front Mounting Ears to Install the Switch .....3-5
3.1.4 Using Front Mounting Ears and a Tray ...................3-7
3.1.5 Using Front and Rear Mounting Ears......................3-8
3.1.6 Using Front Mounting Ears and Guide Rails.........3-12
3.2 Mounting the Switch on a Workbench .............................3-15
3.3 Connecting the Power Cables and the Grounding Cable..........3-16
3.3.1 Connecting the AC Power Cable...........................3-16
3.3.2 Connecting the DC Power Cable ..........................3-18
3.3.3 Connecting the Grounding Cable..........................3-25
3.4 Connecting the Console Cable ........................................3-28
3.4.1 Console Cable .......................................................3-28
3.4.2 Connection Procedure...........................................3-29
3.5 Installing and Removing Optional Interface Modules ......3-30
3.5.1 10 GE XFP Interface Module ................................3-31
3.5.2 Short-haul Dual-port 10 GE CX4 Interface
Module...........................................................................
3-35
3.6 Installing and Removing the Dedicated CX4 Cable.........3-36
3.6.1 Installing the Dedicated CX4 Cable.......................3-36
3.6.2 Removing the Dedicated CX4 Cable.....................3-36
3.7 Verifying the Installation...................................................3-37
Chapter 4 Lightning Protection of the Switch ............................4-1
4.1 Installation of Lightning Arrester for AC Power (Socket Strip
with Lightning Protection).........................................................
4-1