handi quilter Infinity 26 - Laser Operation and Safety

26 | www.HandiQuilter.com
Laser Focus and Image Size
Focus the high-quality laser by turning the threaded housing surrounding the lens clockwise or
counterclockwise. The laser image can be adjusted to project a bigger or smaller dot, or focal size. The
direcon of rotaon needed is determined by the distance of the laser from the pantograph surface.
Experiment by rotang the threaded end to achieve your desired focal size.
Laser Safety
When using the laser stylus, observe the following basic safety precauons.
• Never shine directly into the eyes.
• The laser stylus should never be le on and unaended.
• Do not use the laser stylus as a toy.
• Pay close aenon when the laser stylus is being used by or near children or pets.
• Use the laser stylus only for its intended use as described in this manual.
 NOTE: If you can’t see the threaded housing, the lens may be threaded too far into the laser body.
You will need to use a large sloed screwdriver to turn it counter clockwise unl the housing is
visible. You can then rotate it with your ngerps to bring the light into focus. Be very careful to not
scratch the lens when using the screwdriver.
U CAUTION: Use of controls or adjustments or performance of procedures other than those specied
herein may result in hazardous radiaon exposure.