handi quilter Infinity 26 - Page 74

HQ Innity User Manual | 73
Hard to Guide Machine Correcve Measure(s)
Carriage wheels not centered on
track
• Center the carriage wheels on top of the connuous track. Check
that the machine carriage has not jumped the track.
Thread caught in wheels • Remove all thread or debris in wheels. Check that the tracks are
f r e e o f l i n t an d t h r e ad s .
Motor Fails to Run Correcve Measure(s)
On/O switch turned o • Make sure that both power switches are turned on. First turn on
the rear power switch (to the 1 posion); then turn on the red
power buon on the front-le side of the machine.
Machine not receiving power • Check that the power connector is securely plugged into the
back of the machine and the three-prong end is plugged into the
power source.
Uneven Quilt Design Correcve Measure(s)
Take-up rollers may be bowed or
bent
• Make certain the fabric is not rolled too ght, causing the poles to
bow. Check that poles are inserted completely together with the
push pins engaged so bowing won’t occur.
Leaders are stretched or worn • If fabric is beginning to stretch or fray, contact Handi Quilter to
purchase replacement leaders.
Thread Breaks Correcve Measure(s)
Thread is poor quality or may
have severe twisng or thread
r o t
• Look for severe twisng of threads when approximately 12 to
15 inches has been pulled o, with the ends pinched together.
Coon threads are parcularly suscepble to dry rot or wet rot
which makes thread brile. Do not use poor quality thread, or
thread that is roed or brile.
Top and bobbin tensions not
balanced
• Balance the tension of the needle thread aer ensuring the
bobbin tension is adjusted correctly. (For more informaon about
adjusng tension, see Bobbin and Bobbin Tension and Easy-Touch
Tension™ i n t h e Using Your Machine secon of this manual.)