PAGE 1 - 4 SAFETY / GENERAL MARK IV HD J2 TAMPER
REVISED 10 - 2020 INFORMATION BULLETIN 5082505
1
1.2.2 Safety Information
■ REFER TO ENERGY CONTROL PROCEDURE TO REMOVE ALL ENERGY
SOURCES FROM MACHINE BEFORE PERFORMING MAINTENANCE, OR
MAKING ADJUSTMENTS OR REPAIRS TO MACHINE.
■ ENSURE THAT MACHINE IS FULLY FUNCTIONAL BEFORE OPERATING.
■ NO RIDERS SHALL BE ALLOWED ON THIS EQUIPMENT AT ANY TIME.
■ UNDERSTAND MACHINE OPERATION AND BE AWARE OF ALL PINCH
POINTS BEFORE OPERATING OR MAKING ADJUSTMENTS TO MACHINE.
■ DO NOT WEAR LOOSE CLOTHING AND KEEP ALL PARTS OF BODY
CLEAR OF ALL MOVING PARTS OF MACHINE.
■ BE SURE ALL PERSONS ARE CLEAR OF MACHINE BEFORE OPERATING
ANY FUNCTION.
■ DO NOT TOUCH OR SERVICE ENGINE COMPONENTS, EXHAUST
COMPONENTS, RADIATOR, PUMP DRIVE, OIL COOLER, HYDRAULIC
PUMPS, MOTORS, VALVES, AIR COMPRESSOR, ETC. WHEN THEY ARE
HOT. HOT SURFACES CAN CAUSE SERIOUS BURNS.
■ ALL HOSES AND FITTINGS ON MACHINE MUST COMPLY WITH SAE J1273
- RECOMMENDED PRACTICES FOR HYDRAULIC HOSE ASSEMBLIES.
■ DO NOT OPERATE MACHINE WITHOUT ALL SHIELDS AND MACHINE
GUARDS IN PLACE. REPLACE WORN OR DAMAGED SHIELDS AND
GUARDS.
■ WHEN REMOVING AIR LINES, FITTINGS OR COMPONENTS:
● ALWAYS WEAR APPROPRIATE PERSONAL SAFETY EQUIPMENT.
● REFER TO ENERGY CONTROL PROCEDURE TO REMOVE ALL
ENERGY SOURCES FROM MACHINE BEFORE PERFORMING
MAINTENANCE, OR MAKING ADJUSTMENTS OR REPAIRS TO
MACHINE.
● DEPRESSURIZE AIR SYSTEM. ESCAPING AIR CAN WHIP HOSES AND
EXPEL FITTINGS OR COMPONENTS AT HIGH VELOCITY.
● REMOVE LINES, FITTINGS OR COMPONENTS SLOWLY TO RELEASE
ANY TRAPPED PRESSURE.
● NEVER EXCEED RECOMMENDED AIR PRESSURES.
● NEVER LOOK INTO AIR JETS OR DIRECT THEM AT ANYONE.
WARNING
To Next Page
Loading...