Application
14 A0608-14.0 HBM: public T10F
4 Application
The T10F torque flanges record static and dynamic
torque on stationary or rotating shafts and determine the
speed, specifying the direction of rotation. Test beds can
be extremely compact because of their extremely short
construction. They therefore offer a very wide range of
applications.
In addition to conventional test‐bench engineering
(engine, roll and transmission test benches), new
solutions are possible for torque measurements partly
integrated in the machines. Here, you benefit in full from
the T10F torque flange special characteristics:
S Extremely compact construction with the
measurement flange body
S High permissible dynamic load
S High permissible lateral forces and bending moments
S Very high torsional stiffness
S No bearings, no slip rings
Designed to work without bearings, and with contactless
excitation voltage and measured value transmission, the
measurement flanges are maintenance‐free. Thus there
are no friction or bearings heating effects.
The torque flanges are supplied for nominal (rated)
torques from 50 N⋅m to 10 kN⋅m. Depending on the
nominal (rated) torque, maximum speeds of up to 15 000
min
-1
are permissible.
T10F torque flanges are reliably protected against
electromagnetic interference. They have been tested with
regard to EMC according to the relevant European
standards, and carry the CE mark.
To Next Page
Loading...
Need help?
General
