Electrical connection
42 A0608-14.0 HBM: public T10F
To allow for adaptation to various conditions, there are
three switches in the stator housing, which can be
accessed by removing the stator cover.
Switches
Fig. 7.3 Switches in the stator housing
Switch
position
Example applications
1 a) Older amplifiers
b) For when the calibration signal is unintentionally
initiated with very short cables
2 Normal position (factory setting)
3 For cable lengths in excess of approx. 20 m
Please ensure that after changing to switch position 3,
the calibration signal is not initiated.
To Next Page
Loading...
Need help?
General
