HEIDENHAIN iTNC 530 269
9.7 Additional Functions
1042 Traverse direction not defined
1043 No datum table active
1044 Position error: center in axis 1
1045 Position error: center in axis 2
1046 Hole diameter too small
1047 Hole diameter too large
1048 Stud diameter too small
1049 Stud diameter too large
1050 Pocket too small: rework axis 1.A.
1051 Pocket too small: rework axis 2.A.
1052 Pocket too large: scrap axis 1.A.
1053 Pocket too large: scrap axis 2.A.
1054 Stud too small: scrap axis 1.A.
1055 Stud too small: scrap axis 2.A.
1056 Stud too large: rework axis 1.A.
1057 Stud too large: rework axis 2.A.
1058 TCHPROBE 425: length exceeds max
1059 TCHPROBE 425: length below min
1060 TCHPROBE 426: length exceeds max
1061 TCHPROBE 426: length below min
1062 TCHPROBE 430: diameter too large
1063 TCHPROBE 430: diameter too small
1064 No measuring axis defined
1065 Tool breakage tolerance exceeded
1066 Enter Q247 unequal to 0
1067 Enter Q247 greater than 5
1068 Datum table?
1069 Enter Q351 unequal 0
1070 Thread depth too large
Error number Text
To Next Page
Loading...
Need help?
General
