270 Programming: Q Parameters
9.7 Additional Functions
1071 Missing calibration data
1072 Tolerance exceeded
1073 Block scan active
1074 ORIENTATION not permitted
1075 3-D ROT not permitted
1076 Activate 3-D ROT
1077 Enter a negative value for the depth
1078 Q303 not defined in measuring cycle
1079 Tool axis not allowed
1080 Calculated values incorrect
1081 Contradictory measuring points
1082 Clearance height entered incorrectly
1083 Contradictory type of plunging
1084 Machining cycle not permitted
1085 Line is write-protected
1086 Oversize greater than depth
1087 No point angle defined
1088 Contradictory data
1089 Slot position 0 not permitted
1090 Enter infeed unequal to 0
1091 Switchover of Q399 not allowed
1092 Tool not defined
1093 Tool number not permitted
1094 Tool name not allowed
1095 Software option not active
1096 Kinematics cannot be restored
1097 Function not permitted
1098 Contradictory workpc. blank dim.
1099 Measuring position not allowed
Error number Text
To Next Page
Loading...
Need help?
General
