HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING

To Next Page

To Previous Page

New Cycle Functions of Software 340 49x-06

New Cycle Functions of Software

340 49x-06

 New Cycle 275 "Trochoidal Contour Slot"(see “TROCHOIDAL SLOT

(Cycle 275, DIN/ISO: G275)” on page 205)

 In Cycle 241 "Single-Fluted Deep-Hole Drilling" it is now possible to

define a dwell depth (see “SINGLE-FLUTED DEEP-HOLE DRILLING

(Cycle 241, DIN/ISO: G241)” on page 98)

 The approach and departure behavior of Cycle 39 "Cylinder Surface

Contour" can now be adjusted (see “Cycle run” on page 230)

 New touch probe cycle for calibration of a touch probe on a

calibration sphere (see “CALIBRATE TS (Cycle 460, DIN/ISO:

G460)” on page 458)

 KinematicsOpt: An additional parameter for determination of the

backlash in a rotary axis was introduced (see “Backlash” on page

473)

 KinematicsOpt: Better support for positioning of Hirth-coupled axes

(see “Machines with Hirth-coupled axes” on page 469)

HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING - Page 14