HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING - Fixed Cycles: Tapping; Thread Milling

24
4.1 Basics ..... 106
Overview ..... 106
4.2 TAPPING NEW with a Floating Tap Holder (Cycle 206, DIN/ISO: G206) ..... 107
Cycle run ..... 107
Please note while programming: ..... 107
Cycle parameters ..... 108
4.3 RIGID TAPPING without a Floating Tap Holder NEW (Cycle 207, DIN/ISO: G207) ..... 109
Cycle run ..... 109
Please note while programming: ..... 110
Cycle parameters ..... 111
4.4 TAPPING WITH CHIP BREAKING (Cycle 209, DIN/ISO: G209) ..... 112
Cycle run ..... 112
Please note while programming: ..... 113
Cycle parameters ..... 114
4.5 Fundamentals of Thread Milling ..... 115
Prerequisites ..... 115
4.6 THREAD MILLING (Cycle 262, DIN/ISO: G262) ..... 117
Cycle run ..... 117
Please note while programming: ..... 118
Cycle parameters ..... 119
4.7 THREAD MILLING/COUNTERSINKING (Cycle 263, DIN/ISO: G263) ..... 120
Cycle run ..... 120
Please note while programming: ..... 121
Cycle parameters ..... 122
4.8 THREAD DRILLING/MILLING (Cycle 264, DIN/ISO: G264) ..... 124
Cycle run ..... 124
Please note while programming: ..... 125
Cycle parameters ..... 126
4.9 HELICAL THREAD DRILLING/MILLING (Cycle 265, DIN/ISO: G265) ..... 128
Cycle run ..... 128
Please note while programming: ..... 129
Cycle parameters ..... 130
4.10 OUTSIDE THREAD MILLING (Cycle 267, DIN/ISO: G267) ..... 132
Cycle run ..... 132
Please note while programming: ..... 133
Cycle parameters ..... 134
4.11 Programming Examples ..... 136
4 Fixed Cycles: Tapping / Thread Milling ..... 105