HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING - Cycles: Special Functions

HEIDENHAIN iTNC 530 33
12.1 Fundamentals ..... 302
Overview ..... 302
12.2 DWELL TIME (Cycle 9, DIN/ISO: G04) ..... 303
Function ..... 303
Cycle parameters ..... 303
12.3 PROGRAM CALL (Cycle 12, DIN/ISO: G39) ..... 304
Cycle function ..... 304
Please note while programming: ..... 304
Cycle parameters ..... 305
12.4 ORIENTED SPINDLE STOP (Cycle 13, DIN/ISO: G36) ..... 306
Cycle function ..... 306
Please note while programming: ..... 306
Cycle parameters ..... 306
12.5 TOLERANCE (Cycle 32, DIN/ISO: G62) ..... 307
Cycle function ..... 307
Influences of the geometry definition in the CAM system ..... 308
Please note while programming: ..... 309
Cycle parameters ..... 310
12 Cycles: Special Functions ..... 301