HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING - Cycles: Coordinate Transformations

HEIDENHAIN iTNC 530 31
11.1 Fundamentals ..... 272
Overview ..... 272
Effect of coordinate transformations ..... 273
11.2 DATUM SHIFT (Cycle 7, DIN/ISO: G54) ..... 274
Effect ..... 274
Cycle parameters ..... 274
11.3 DATUM Shift with Datum Tables (Cycle 7, DIN/ISO: G53) ..... 275
Effect ..... 275
Please note while programming: ..... 276
Cycle parameters ..... 277
Selecting a datum table in the part program ..... 277
Editing the datum table in the Programming and Editing mode of operation ..... 278
Editing a pocket table in a Program Run operating mode ..... 279
Transferring the actual values into the datum table ..... 279
Configuring the datum table ..... 280
To exit a datum table ..... 280
11.4 DATUM SETTING (Cycle 247, DIN/ISO: G247) ..... 281
Effect ..... 281
Please note before programming: ..... 281
Cycle parameters ..... 281
11.5 MIRROR IMAGE (Cycle 8, DIN/ISO: G28) ..... 282
Effect ..... 282
Please note while programming: ..... 282
Cycle parameters ..... 283
11.6 ROTATION (Cycle 10, DIN/ISO: G73) ..... 284
Effect ..... 284
Please note while programming: ..... 284
Cycle parameters ..... 285
11.7 SCALING (Cycle 11, DIN/ISO: G72) ..... 286
Effect ..... 286
Cycle parameters ..... 287
11.8 AXIS-SPECIFIC SCALING (Cycle 26) ..... 288
Effect ..... 288
Please note while programming: ..... 288
Cycle parameters ..... 289
11 Cycles: Coordinate Transformations ..... 271