8
TNC Model, Software and Features
Feature content level (upgrade functions)
Along with software options, significant further improvements of the
TNC software are managed via the Feature Content Level (FCL)
upgrade functions. Functions subject to the FCL are not available
simply by updating the software on your TNC.
Upgrade functions are identified in the manual with FCL n, where n
indicates the sequential number of the feature content level.
You can purchase a code number in order to permanently enable the
FCL functions. For more information, contact your machine tool
builder or HEIDENHAIN.
All upgrade functions are available to you without
surcharge when you receive a new machine.
FCL 4 functions Description
Graphical depiction of the protected
space when DCM collision monitoring is
active
User’s Manual
Handwheel superimposition in stopped
condition when DCM collision
monitoring is active
User’s Manual
3-D basic rotation (set-up
compensation)
Machine manual
FCL 3 functions Description
Touch probe cycle for 3-D probing Page 451
Touch probe cycles for automatic datum
setting using the center of a slot/ridge
Page 345
Feed-rate reduction for the machining of
contour pockets with the tool being in
full contact with the workpiece
User’s Manual
PLANE function: Entry of axis angle User’s Manual
User documentation as a
context-sensitive help system
User’s Manual
smarT.NC: Programming of smarT.NC
and machining can be carried out
simultaneously
User’s Manual
smarT.NC: Contour pocket on point
pattern
smarT.NC Pilot
To Next Page
Need help?
General
