HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING - Page 9

HEIDENHAIN iTNC 530 9
TNC Model, Software and Features
Intended place of operation
The TNC complies with the limits for a Class A device in accordance
with the specifications in EN 55022, and is intended for use primarily
in industrially-zoned areas.
smarT.NC: Preview of contour
programs in the file manager
smarT.NC Pilot
smarT.NC: Positioning strategy for
machining point patterns
smarT.NC Pilot
FCL 2 functions Description
3-D line graphics User’s Manual
Virtual tool axis User’s Manual
USB support of block devices (memory
sticks, hard disks, CD-ROM drives)
User’s Manual
Filtering of externally created contours User’s Manual
Possibility of assigning different depths
to each subcontour in the contour
formula
User’s Manual
DHCP dynamic IP-address
management
User’s Manual
Touch-probe cycle for global setting of
touch-probe parameters
Page 456
smarT.NC: Graphic support of block
scan
smarT.NC Pilot
smarT.NC: Coordinate transformation smarT.NC Pilot
smarT.NC: PLANE function smarT.NC Pilot
FCL 3 functions Description