HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING User Manual

HEIDENHAIN iTNC 530 53
2.2 Program Defaults for Cycles
2.2 Program Defaults for Cycles
Overview
All Cycles 20 to 25, as well as all of those with numbers 200 or higher,
always use identical cycle parameters, such as the setup clearance
Q200, which you must enter for each cycle definition. The GLOBAL DEF
function gives you the possibility of defining these cycle parameters
once at the beginning of the program, so that they are effective
globally for all fixed cycles used in the program. In the respective fixed
cycle you then simply link to the value defined at the beginning of the
program.
The following GLOBAL DEF functions are available:
Machining pattern Soft key Page
GLOBAL DEF COMMON
Definition of generally valid cycle
parameters
Page 55
GLOBAL DEF DRILLING
Definition of specific drilling cycle
parameters
Page 55
GLOBAL DEF POCKET MILLING
Definition of specific pocket-milling cycle
parameters
Page 56
GLOBAL DEF CONTOUR MILLING
Definition of specific contour milling
parameters
Page 56
GLOBAL DEF POSITIONING
Definition of the positioning behavior for
CYCL CALL PAT
Page 56
GLOBAL DEF PROBING
Definition of specific touch probe cycle
parameters
Page 57

HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530 - CYCLE PROGRAMMING
Category	Control Panel
Language	English