HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING - Fixed Cycles: Multipass Milling

30
10.1 Basics ..... 254
Overview ..... 254
10.2 RUN 3-D DATA (Cycle 30, DIN/ISO: G60) ..... 255
Cycle run ..... 255
Please note while programming: ..... 255
Cycle parameters ..... 256
10.3 MULTIPASS MILLING (Cycle 230, DIN/ISO: G230) ..... 257
Cycle run ..... 257
Please note while programming: ..... 257
Cycle parameters ..... 258
10.4 RULED SURFACE (Cycle 231, DIN/ISO: G231) ..... 259
Cycle run ..... 259
Please note while programming: ..... 260
Cycle parameters ..... 261
10.5 FACE MILLING (Cycle 232, DIN/ISO: G232) ..... 263
Cycle run ..... 263
Please note while programming: ..... 264
Cycle parameters ..... 265
10.6 Programming Examples ..... 268
10 Fixed Cycles: Multipass Milling ..... 253