10
New Cycle Functions of Software 340 49x-02
New Cycle Functions of Software
340 49x-02
New machine parameter for defining the positioning speed (see
“Touch trigger probe, rapid traverse for positioning: MP6151” on
page 317)
New machine parameter for consideration of basic rotation in
Manual Operation (see “Consider a basic rotation in the Manual
Operation mode: MP6166” on page 316)
Cycles 420 to 431 for automatic tool measurement were improved
so that the measuring log can now also be displayed on the screen
(see “Recording the results of measurement” on page 397)
A new cycle that enables you to set global touch probe parameters
was introduced (see “FAST PROBING (Cycle 441, DIN/ISO: G441,
FCL 2 Function)” on page 456)
To Next Page
Loading...
