254 Fixed Cycles: Multipass Milling
10.1 Basics
10.1 Basics
Overview
The TNC offers four cycles for machining surfaces with the following
characteristics:
Created with a CAD/CAM system
Flat, rectangular surfaces
Flat, oblique-angled surfaces
Surfaces that are inclined in any way
Twisted surfaces
Cycle Soft key Page
30 RUN 3-D DATA
For multipass milling of 3-D data in
several infeeds
Page 255
230 MULTIPASS MILLING
For flat rectangular surfaces
Page 257
231 RULED SURFACE
For oblique, inclined or twisted surfaces
Page 259
232 FACE MILLING
For level rectangular surfaces, with
indicated oversizes and multiple infeeds
Page 263
To Next Page
Loading...
