HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING - Page 285

HEIDENHAIN iTNC 530 285
11.6 ROTATION (Cycle 10, DIN/ISO: G73)
Cycle parameters
U Rotation: Enter the rotation angle in degrees (°). Input
range –360.000° to +360.000° (absolute or
incremental)
Example: NC blocks
12 CALL LBL 1
13 CYCL DEF 7.0 DATUM SHIFT
14 CYCL DEF 7.1 X+60
15 CYCL DEF 7.2 Y+40
16 CYCL DEF 10.0 ROTATION
17 CYCL DEF 10.1 ROT+35
18 CALL LBL 1