446 Touch Probe Cycles: Special Functions
17.1 Basics
17.1 Basics
Overview
The TNC provides seven cycles for the following special purposes:
Cycle Soft key Page
2 CALIBRATE TS Radius calibration of
the touch trigger probe
Page 447
9 CALIBRATE TS LENGTH Length
calibration of the touch trigger probe
Page 448
3 MEASURING Cycle for defining OEM
cycles
Page 449
4 MEASURING IN 3-D Measuring cycle
for 3-D probing for defining OEM cycles
Page 451
440 MEASURE AXIS SHIFT Page 453
441 FAST PROBING Page 456
460 CALIBRATE TS Radius and length
calibration on a calibration sphere
Page 458
To Next Page
Loading...
